#1 2015-05-29 01:44:51

avisnofsky
Member
Registered: 2015-05-26
Posts: 11

Humble Request

Hello everyone,
I have been trying to compile the microaprs firmware myself (using the non default options), but no matter what I do I can't get it to build. If anyone has a working build setup, and has a spare minute, would they mind compiling microaprs for me using 3.3v ref, open squelch = true, and using the serial option (not kiss)? I hate to be a pain, but I'm trying to build it on a windows machine, and do not currently have access to a linux box. sad Thanks in advance.

Andy
KC3BHG

Offline

#2 2015-05-29 02:10:36

avisnofsky
Member
Registered: 2015-05-26
Posts: 11

Re: Humble Request

Actually, nevermind. I don't know why I didn't just use atmel studio first. smile Anyway, I finally got it built. Now, hopefully I'll be able to decode OTA packets. smile

Offline

#3 2015-05-29 08:38:35

markqvist
Administrator
Registered: 2014-12-01
Posts: 112

Re: Humble Request

Good to hear you got it building! If you run into problems again, just drop me a note and I'll make a custom build for you smile

Offline

#4 2015-07-31 21:44:30

Henry
Member
Registered: 2015-07-22
Posts: 6

Re: Humble Request

Question: Under what conditions would one want to use open-squelch?

Thanks

Offline

#5 2015-08-05 20:12:46

markqvist
Administrator
Registered: 2014-12-01
Posts: 112

Re: Humble Request

Hi Henry!
If you are running the radio in open squelch, that is if it is not closing the receiver when no signal of sufficient strength is detected. In some cases a weak signal will not trigger the receiver to open, or it will open too late, in which case the packet will be lost. Running in open squelch can make you receive some of those packets that might otherwise be too weak for the radio to open up.

Offline

Board footer

Powered by FluxBB