#1 Re: Software & Programming » KISS Protocol TX Delay Settings » 2018-03-16 00:03:55

Nobody seems to have an answer. May have to dead end the project unfortunately.

#2 Software & Programming » KISS Protocol TX Delay Settings » 2018-03-09 05:04:59

NA7Q
Replies: 2

I built my own version of the MicroAPRS Arduino board with Bluetooth.
My plan is to use it with APRSDroid and sometimes a computer. To the point now.

How can I set the tx delay preamble for the kiss protocol version? I see no way to do this. Using Xastir on the computer I set it to my liking via its settings, but it is not applied. Still transmits with next to nothing delay. APRSDroid doesn't have these settings, so how can I go about setting a 300ms preamble?
Any help would be appreciated.

#4 Re: Introductions » Reply to this post! » 2018-03-06 04:57:58

Just started working on a simple arduino KISS TNC.
Trying to figure out how set the preamble and tail using the precompiled kiss images. Or even change it from the source.
"MicroAPRS supports a subset of the KISS configuration commands." But I see no information on how to set these configs. Any help would be appreciated.

Board footer

Powered by FluxBB